Specifications

Graffiti Glock 18 Hopper Fed Manual Springer Gel Ball Pistol

• Hopper Fed
• Distance up to 10 m
• Uses 7-8 mm gels
• ABS Plastic

Please note this toy is manual and runs of single shot spring power, so there is no need for a battery or green gas.

Included in each Box

• 1 x Graffiti Manual Hopper Fed Glock 18 Gel Ball Pistol
• 1 x Sample Pack Gels – Please note, these are extremely poor quality gels and we recommend not using them, the gels we would recommend are the Predator V2 Ultra Hard Gels.

Operation of this blaster

The manual Hopper Fed Graffiti Glock 18 needs to be operated in a specific way.

• • • Always use 7-8 mm gels that have been well hydrated for at least 4 hours, that are fresh out of water and not too dry.
    • Different brand gels will produce different performance from this product.
    • Load the fully hydrated gels into the top hopper and close the hopper slide.
    • When you load each gel to be fired, point the gel blaster slightly in the upward direction and then load the blaster with a quick action of the slide and then release.
    • When you first load the blaster, it may take a few times to prime the blaster to fire, before the gels are fired out of the blaster.
    • The blaster may not fire a gel for every shot (pull of the trigger), this is common and normal for this blaster.
    • At times the Gel Blaster may fire two gels during one shot, again this is normal for this quality of blaster.
    • Before purchasing, please ensure you understand the above points and understand that this blaster is not perfect, it may not fire a gel every time you pull the trigger and gel firing distance and accuracy may vary with every shot. Two gels may be fired with one shot. This is how most manual gel ball blasters function and is normal for them and this product.
    • Also, please note this is manual spring powered blaster, and the slide has to be racked every time, to prepare the blaster to shoot.

BATTERY

This Product requires no batteries.

Special Note, the slide is made as two halves, which are screwed together. There is a small upside-down “V” shaped gap at the end of the slide, as the screws are only applying pressure on the top of the slide.